[jsb5717]

There's nothing you can do about the bouncy floor in that slide. It's a single layer of plywood...I'm not sure if it's 3/8" or 1/2"...it's inadequate either way. Like mine, your table is likely screwed to the floor. The screws on mine were actually sticking out under the slide through the Darco. I got tired of the table bouncing just trying to sit down in the dining chairs so I remounted the table. It's now attached to the wall under the window with a single leg supporting the other end right at the edge of the slide floor...table bounce gone. The bouncy floor is much less noticeable when the table stays stationary. YMMV.