[Vet4jdc]

2019 Montana High Country 331RL


Our kitchen slide extends out very normal until the very end of the run. As it stops when it gets close to the outside wall, it seems the top front corner pulls out more at the very end when the other 3 corners have stopped. The result when you go outside is the kitchen slide is sitting on an angle to the rig with the top front extended out about 3/4" more than the other three corners.


My question is can this be adjusted to have all four corners stop at the same time so the slide is square and even to the rig? If so what is the adjustment process?


I know YouTube has videos on adjusting slide cables but that is mostly for loose cables. All of my cables are tight when both opened and closed. Thanks in advance for any help or advice.