Quote:
Originally Posted by Daryles
Here is a picture of the NORMAL valve positions.
To FILL your freshwater tank turn the
"Tank Fill Power Fresh" valve to FILL.
Once full, you will see water run out the freshwater tank overflow vent at the back on the side of your rig (your first picture). Turn the valve back to the NORMAL FLOW position or your water pump will cycle every few minutes. Also make sure your freshwater tank drain cap underneath is screwed on tight.
IF you are traveling with a full freshwater tank, be aware when you turn a right hand corner (highway clover leaf) you will see water spraying out this vent. Centrifugal force and hydrodynamic.
Looking at your water heater picture, it looks like the water is coming out the anode hole where the anode rod goes in. Use teflon tape on the anode rod threads and do NOT OVER tighten it. It's a tapered fitting.
|
I am hooked to a water supply not running off of tanks what position should the water heater valve be in when hooked up to a water hose not running off with the freshwater tanks thank you I'm new to all this