[Foldbak]

Originally Posted by GregoryL

I have a 2015 Montana High Country, and I love the Lippert Leveling system.
However the last two times I was doing Auto Level as the system is almost complete I get Out of Stroke message.
First time it happened I re-homed the system by extending front and rear at least 6 inches and then hit Retract All, which should correct it.
But the next time I did Auto level, as it is almost complete I get the Out of Stroke message again.
The legs aren't over extended with LF 5.1 inch, RF 5.6 inch, LR 6.5 and RR 6.5.
Any ideas what the problem could be or how to reset it?

Out of stroke simply means that one or more of the landing legs have extended as far as it can and the trailer isn't level. Typically you would retract all and add blocks. You should be fine. In your case if you're only able to extend the legs 5 or 6" then you probably need to reset.

You should download the lippert now app on your phone.

https://support.lci1.com/ground-cont...ol-touch-panel

Here's how to reset
Turn the power to the system OFF.
Press “Front” five times.
Press “Rear” five times. At this point the panel will read “ZERO POINT CALIBRATION” and all lights (front, right, left, rear) will flash.
Press ENTER to reset the auto level control.

Good luck