|
I want to thank everyone for your support. I too watched the spider video and unfortunately my furnace is located on that side of the hot water heater. however, I have access from the other side as it is fully open. There are no error messages. Cutting holes in the side panel is not an option either as I have found that the burner only ignites when the panel is completely removed. Anything less and the burner will not ignite. As mentioned earlier, there are two areas inside the hot water heater, one for the burner and the other side holds all the electronics. They are completely separate. I will look at the diaphragm type single tube pressure switch and see if it is the issue.
|