[masterdrago]

Originally Posted by glendodom

On the RF18HFENBSR model in trying to get that front panel off to check for ice/frost on the coil is there any trade secrets to getting it off? It has 2 screws at the bottom and one that is up center top that was behind a small cover (it was all iced over). Even after removal of these 3 screws and popping the panels out from each side, the panel cover is loose at the bottom area but still tight at the top portion. I didn't want to put too much pressure on trying to pull it away. Other than let it sit for a few hours to hopefully defrost, to then remove the front panel to verify all the frost is gone, is there any other suggestions?

It has to be defrosted thoroughly b4 the panel will be easy to remove. It might take a day or two. It should then almost fall off.