Thank you Tony and Donna - Although I tried some of your suggestions, you offered up some I should re-check!
FYI - what I've done.
1. Verified the 20A top-hat fuse (push button) on Inverter was not thrown.
2. Verified none of the DC fuses at fuse box were thrown/blown
3. I did switch the Inverter Disconnect switch a couple of times to verify electricity was flowing - I looked that all LED indications on the remote display at the control center were off then on again when Inverter Disconnect was in the on position.
However - what I didn't do, after reviewing some of your attachments - was to press the green "check" button/power button on the remote AFTER changing the mode of PS0 to PS1.
Thanks for your feedback!
|