|
Well, I would say the mattress stand and/or under bed storage area can be over loaded as we did just that by adding a pretty dense mattress pad and storing a bunch of gear under the bed. As RSO mentions above, the bed is cantilevered when pulled-in. Over time our frame loosened from the wall from the weight on cantilever tilting the bed so much and appears that it see/sawed while going over the factory rollers on the floor. Besides re-securing the bed frame, and reducing the gear, we had to take care of the cantilever as RSO mentions. Our solution was to buy another pair of 3-4 inch long rollers like the factory installed ones. They’re available on Amazon for about $30 pair. Installed them on the bed frame/storage area so they support the end of the frame. Picture shows how the rollers sit with the bedroom extended. (The factory rollers are on the right.) I suppose the rollers could impress the floor over time but so far, so good.
|