|
The slide out switch sends a 12 volt DC plus voltage directly from the switch to the hydac valve for the slide outs…
There is only ONE Hydac valve for ALL hydraulic slides..
My switch wiring (OEM) the blue wire shown on the switch runs directly to the hydac valve on your manifold..
Second 8mage shows blue wire that runs from slide switch to that hydac valve mounted on the manifold…
Your wiring may look slightly different but principle and wiring convention will,he the same..
Last image from a Lippert PDF shows green and yellow wires from slide switch to extend/retract terminals on dual polarity solenoid
The slide out switch also sends a 12 volt signal to,either extend or retract side of dual polarity solenoid
The images are from my fifth wheel and are part of a TS PDF I wrote for another group…too large of file to UL here … it is about 3.6mb
|