|
Thanks for the info! I started at the pump and discovered immediately the source line was completely kinked. I’m not even sure how I was getting any water and very glad it didn’t crack or burst. The other side was nearly as bad. The factory used 20” lines where only a 12” line should have been used. I repositioned the lines and now everything is working much better! The lines will need replaced as the area of the kink is very soft now but it will be fine for now. I also had to tighten some of the fittings as they were also loose. Only one was wet but I checked them all anyway. Just another line on my two page “to do list” for the shop if I can ever get it in for the warranty work…
|