|
04-02-2022, 11:19 AM
|
#1
|
New Member
Join Date: Nov 2021
Location: St. Augustine
Posts: 6
M.O.C. #30127
|
CSW2012-HX Inverter Not Powering Up
My unit is a 2022 High Country 331RL e/w SolarFlex 200 that we purchased Feb 1, 2022 from CW - we just got it back after 5-weeks at CW Service (which I have zero confidence that they know what they are doing) for roof warranty work and to have them replace the positive and negative cables from the battery to the unit as they are too short to allow the battery box to close (which they did nit do).
Here is the problem when we got home - we plugged into shore power and turned on the refrigerator which it did turn on. I wanted to make sure that the inventor was on so I disconnected the shore power to make sure that the inverter powered the refrigerator if we were to loose power here at the house. Well no power from the inventor!
I have a CSW2012-HX inverter and the display panel shows 14.1v – Status & Display are both green. The codes that are displayed when I press the Select button are P51, AL1, 5DL. However, I cannot find a User Manual for the CSW2012-HX, the only one on the Magnum-Dimensions Products website is for the CSW2012-H.
This is our 4th 5th wheel and the first with a residential refrigerator and inverter. Any suggestions?
|
|
|
04-02-2022, 02:13 PM
|
#2
|
Site Team
Join Date: Oct 2005
Location: Carmichael - CA
Posts: 7,324
M.O.C. #4831
|
The CSW2012-HX is an update to the CSW2012-H, Take a look at the Magnum Inverters page *HERE* You should find this link to your manual
https://www.magnum-dimensions.com/si...W2012-X%29.pdf
The manual starts with this explanation:
"Addendum for use with CSW2012-HX
The CSW1012-HX comes with hardwire AC Input and hardwire AC Output cable with a Display Port for Remote Display. An Ignition Start Port is added to control the unit ON and OFF by using an external signal and the USB output port is removed. Other feature and function are the same as the CSW2012-X.
Use the following section to understand the unit’s features of CSW2012-HX in replace of “1.1 Features” on page 1 and 2 of the CSW2012-X Owner’s Manual."
__________________
Carl (n Susan)
There is more to life than fuel mileage.
2012 Montana 3700RL Big Sky Package towed by a 2015 Ford F350 6.7L PSD 4WD CC LWB
|
|
|
04-02-2022, 07:38 PM
|
#3
|
Montana Master
Join Date: Dec 2021
Location: Northeast TX
Posts: 932
M.O.C. #30262
|
Quote:
Originally Posted by Carl n Susan
The CSW2012-HX is an update to the CSW2012-H, Take a look at the Magnum Inverters page *HERE* You should find this link to your manual
https://www.magnum-dimensions.com/si...W2012-X%29.pdf
The manual starts with this explanation:
"Addendum for use with CSW2012-HX
The CSW1012-HX comes with hardwire AC Input and hardwire AC Output cable with a Display Port for Remote Display. An Ignition Start Port is added to control the unit ON and OFF by using an external signal and the USB output port is removed. Other feature and function are the same as the CSW2012-X.
Use the following section to understand the unit’s features of CSW2012-HX in replace of “1.1 Features” on page 1 and 2 of the CSW2012-X Owner’s Manual."
|
Thanks for posting this up for all of us Carl. This is a lot more information that I had before on our unit. I'll be pouring over the info on our next trip in a couple of weeks. Most trips are short, but we have one long trip scheduled for later on late this summer and I want to ensure the residential fridge will stay online during the road trip.
__________________
Lee, Edith, Lil' Bit & Cuddles
22 MHC 331RL, Surge Guard 35550, SumoSprings, Kodiak disc brakes, 412Ah Lithium, Gen 3 Goosebox, Sailun 85s
22 Ram 3500 CC DRW 6.7 CTD Herrin Hauler Classic Bed, 45 gal AUX tank
|
|
|
06-24-2022, 12:36 PM
|
#4
|
New Member
Join Date: Jun 2022
Location: Oakland
Posts: 2
M.O.C. #31241
|
I am having the same exact problem but I don’t think my Inverter HX has ever worked. I have tried many different things with no luck. Please post if you have found a solution. Thanks!
|
|
|
06-24-2022, 02:29 PM
|
#5
|
Montana Master
Join Date: Dec 2021
Location: Northeast TX
Posts: 932
M.O.C. #30262
|
Once AC power is off, i have to cycle the DC input switch to the CSW2012-HX Off and then back On again before the unit will go into invert mode. The transfer relay inside the inverter isn't functioning properly. I'm still awaiting replacement from M-I since April.
__________________
Lee, Edith, Lil' Bit & Cuddles
22 MHC 331RL, Surge Guard 35550, SumoSprings, Kodiak disc brakes, 412Ah Lithium, Gen 3 Goosebox, Sailun 85s
22 Ram 3500 CC DRW 6.7 CTD Herrin Hauler Classic Bed, 45 gal AUX tank
|
|
|
06-24-2022, 07:01 PM
|
#6
|
Montana Master
Join Date: Jan 2022
Location: Shingle Springs
Posts: 2,152
M.O.C. #30417
|
I went through this as well. I had to cycle the inverter battery switch to turn on the inverter. The unit is programed to PS1 which disables the power switch on the remote. I programmed mine to PS4 enabling the power switch. It allows me to turn off the inverter when in storage but to turn it on I have to have the Gen running or shore power plugged in. Once its on I can turn off the gen. Obviously not a good option if you don't have a gen. I think it's a design flaw that the TS in the inverter doesn't work correctly. This is my second unit with the same outcome. But at PS4 it work fine for me.
__________________
Tony & Donna
2022 Montana HC, 295RL, Solar Flex 400, Onan 3600 LPG, 2K inverter, 200AH Lithium. 2020 GMC Denali 2500 6.6 Duramax, Demco 21K Auto Slide
|
|
|
06-25-2022, 07:44 AM
|
#7
|
New Member
Join Date: Jun 2022
Location: Oakland
Posts: 2
M.O.C. #31241
|
Where is the DC input switch on the inverter? I didn’t think the HX version had one but may be wrong!
|
|
|
06-25-2022, 08:04 AM
|
#8
|
Montana Master
Join Date: Jan 2022
Location: Shingle Springs
Posts: 2,152
M.O.C. #30417
|
They all have a battery cutoff switch. It depends on the inverter location. Typically the inverter is located within 6 feet of the batteries. The inverter is connected to batteries with large black and red battery cables. The switch is in line with the red or positive cable. Just follow the wire. And there should be a remote switch that powers on the inverter if it's programed to do so.
__________________
Tony & Donna
2022 Montana HC, 295RL, Solar Flex 400, Onan 3600 LPG, 2K inverter, 200AH Lithium. 2020 GMC Denali 2500 6.6 Duramax, Demco 21K Auto Slide
|
|
|
02-12-2023, 07:17 AM
|
#9
|
New Member
Join Date: Feb 2023
Location: Chilhowie
Posts: 3
M.O.C. #32322
|
Quote:
Originally Posted by Foldbak
I went through this as well. I had to cycle the inverter battery switch to turn on the inverter. The unit is programed to PS1 which disables the power switch on the remote. I programmed mine to PS4 enabling the power switch. It allows me to turn off the inverter when in storage but to turn it on I have to have the Gen running or shore power plugged in. Once its on I can turn off the gen. Obviously not a good option if you don't have a gen. I think it's a design flaw that the TS in the inverter doesn't work correctly. This is my second unit with the same outcome. But at PS4 it work fine for me.
|
How do you program for PS4?
|
|
|
02-12-2023, 08:38 AM
|
#10
|
New Member
Join Date: Feb 2023
Location: Chilhowie
Posts: 3
M.O.C. #32322
|
I found the answer to the inverter not working issue. It took a lot of Google searches and scratching my head with frustration.
If you have the CSW2012-HX inverter you need to make sure you have the right manual. The manual I received with my Montana High Country 295RL is the CSW2012 manual. If that is the manual you have throw it away!
The correct manual is the CSW2012X along with an addendum for the CSW2012-HX.
So here is the fix to the inverter problem: The remote display unit indicated that the inverter was disabled (PS0). You can change the setting to PS1 using the remote display unit. Follow the instructions in the CSW2012X manual in section 3.
http://magnum-dimensions.com
There's your link for Magnum Dimensions for the manuals.
|
|
|
|
Thread Tools |
Search this Thread |
|
|
Display Modes |
Linear Mode
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|