 |
01-03-2019, 11:25 AM
|
#1
|
|
Montana Master
Join Date: Dec 2010
Location: Sioux Falls
Posts: 664
M.O.C. #10985
|
pop up electrical outlets
My pop up elect tower by the stove on my 3791 has 2 outlets of which only 1 works. How do I get it apart to replace or repair?
|
|
|
|
01-03-2019, 12:45 PM
|
#2
|
|
Montana Master
Join Date: May 2011
Location: Hixson
Posts: 3,436
M.O.C. #11397
|
You should be able to access it from below by removing the top drawer next to the oven. Be SURE power is OFF!
__________________
2018.5 Montana 3791RD
Full Timers 9/1/2010 through 1/16/2020.
|
|
|
|
|
01-03-2019, 01:08 PM
|
#3
|
|
Montana Master
Join Date: Aug 2018
Location: Minden - NV
Posts: 509
M.O.C. #22360
|
There's also a threaded ring nut that holds them down to the counter.
__________________
2013 F350 Lariat Ultimate CC LB
2019 3790RD
|
|
|
|
|
01-04-2019, 12:26 PM
|
#4
|
|
Montana Master
Join Date: Aug 2018
Location: Minden - NV
Posts: 509
M.O.C. #22360
|
I was digging through my photos and found this shot of the pop-up plug under the counter.
It plugs into the outlet on the left so you could remove it and work on it at a bench for better access.
__________________
2013 F350 Lariat Ultimate CC LB
2019 3790RD
|
|
|
|
|
06-07-2023, 06:46 PM
|
#5
|
|
New Member
Join Date: Oct 2022
Location: Centennial
Posts: 4
M.O.C. #31838
|
Electrical tower by table.
Any idea how to acces the one by the table? Seems to be fully enclosed. It feels like it will unscrew but I’m afraid the other half will fall into the void. Keystone Montana 3790RD
|
|
|
|
|
06-07-2023, 06:52 PM
|
#6
|
|
Montana Master
Join Date: Aug 2018
Location: Minden - NV
Posts: 509
M.O.C. #22360
|
You have to remove the paneling on the side of the table and renail it. It's not to intrusive or hard to get off without damaging it.
__________________
2013 F350 Lariat Ultimate CC LB
2019 3790RD
|
|
|
|
|
06-10-2023, 12:15 PM
|
#7
|
|
New Member
Join Date: Oct 2022
Location: Centennial
Posts: 4
M.O.C. #31838
|
Quote:
Originally Posted by jetskier
You have to remove the paneling on the side of the table and renail it. It's not to intrusive or hard to get off without damaging it.
|
Thank you, I was afraid that was going to be the solution.
|
|
|
|
|
06-07-2023, 07:46 PM
|
#8
|
|
Montana Master
Join Date: Jan 2022
Location: Shingle Springs
Posts: 2,758
M.O.C. #30417
|
Quote:
Originally Posted by Dcowden0051
Any idea how to acces the one by the table? Seems to be fully enclosed. It feels like it will unscrew but I’m afraid the other half will fall into the void. Keystone Montana 3790RD
|
Welcome to the MOC
__________________
Tony & Donna & the best dog ever, Murphy.
2022 Montana HC, 295RL, 720 watts Solar, Onan 3600 LPG, 2K inverter, 200AH Lithium. 2020 GMC Denali 2500 6.6 Duramax, Demco 21K Auto Slide
|
|
|
|
|
06-07-2023, 08:18 PM
|
#9
|
|
Montana Master
Join Date: Jan 2018
Location: Granger TX
Posts: 2,783
M.O.C. #21044
|
Dcowden - my unit is a 2018. I used a flat head screw driver to pry the end panel off starting at the bottom corner next to the outside wall. Work it a little bit at a time. The panel is held on by wire staples. I slowly worked it off working from the bottom up, and then pulled the staples out of the panel. I replaced my pop-up outlet (the USBs went dead) - then I put the panel back on using finish screws. That way it will be easy to remove if needed in the future. Just work it slow - it will come off.
__________________
MikenDebbie Aggie ‘77 in the sticks near Austin TX
2019 Chevy 3500 High Country DRW
2018 Montana 3921FB
Aussie Gus + Texas Heeler Jimmy
|
|
|
|
|
06-23-2023, 09:00 PM
|
#10
|
|
New Member
Join Date: Oct 2022
Location: Centennial
Posts: 4
M.O.C. #31838
|
Thank you!
Quote:
Originally Posted by Mikendebbie
Dcowden - my unit is a 2018. I used a flat head screw driver to pry the end panel off starting at the bottom corner next to the outside wall. Work it a little bit at a time. The panel is held on by wire staples. I slowly worked it off working from the bottom up, and then pulled the staples out of the panel. I replaced my pop-up outlet (the USBs went dead) - then I put the panel back on using finish screws. That way it will be easy to remove if needed in the future. Just work it slow - it will come off.
|
Thank you, I’ll give it a go!
|
|
|
|
|
06-07-2023, 08:18 PM
|
#11
|
|
Site Team
Join Date: Oct 2005
Location: Carmichael - CA
Posts: 7,841
M.O.C. #4831
|
Quote:
Originally Posted by Dcowden0051
Any idea how to acces the one by the table? Seems to be fully enclosed. It feels like it will unscrew but I’m afraid the other half will fall into the void. Keystone Montana 3790RD
|
Here is a previous post on this problem with pictures and links to other related posts. It should help you.
https://www.montanaowners.com/forums...ad.php?t=80887
__________________
Carl (n Susan)
There is more to life than fuel mileage.
2012 Montana 3700RL Big Sky Package towed by a 2015 Ford F350 6.7L PSD 4WD CC LWB
|
|
|
|
|
06-24-2023, 06:57 PM
|
#12
|
|
Montana Master
Join Date: Dec 2010
Location: Sioux Falls
Posts: 664
M.O.C. #10985
|
Quote:
Originally Posted by Dcowden0051
Any idea how to acces the one by the table? Seems to be fully enclosed. It feels like it will unscrew but I’m afraid the other half will fall into the void. Keystone Montana 3790RD
|
On my 2018 3791 it is behind the outside TV
|
|
|
|
|
06-25-2023, 02:02 PM
|
#13
|
|
New Member
Join Date: Oct 2022
Location: Centennial
Posts: 4
M.O.C. #31838
|
Thank you
Thank you! I don’t have that on mine. Looks like I’ll be removing the panel.
|
|
|
|
|
08-28-2023, 10:20 AM
|
#14
|
|
New Member
Join Date: Apr 2017
Location: E Newport
Posts: 2
M.O.C. #19673
|
The panel on the end of mine is held on with screws. Very easy, 5 minute fix.
|
|
|
|
|
06-07-2023, 09:13 PM
|
#15
|
|
Seasoned Camper
Join Date: Feb 2019
Location: HOSCHTON
Posts: 83
M.O.C. #23386
|
Another reason my next 5th wheel won't be a Montana or a Keystone.
|
|
|
|
|
| Thread Tools |
Search this Thread |
|
|
|
| Display Modes |
 Hybrid Mode
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
