Okay, it wasn't terrible. I ended up cutting a small hole in the Cloroplast to access the area. Once I did that, it was obvious what the problem was. The nut had come off the end of the cylinder allowing the ram to drop from the attachment point. Not much good there. I replaced the nut and sealed up the hole and all is good again. The slide actually works better than it did. I suspect the nut had been lose for a long time.
__________________
2017 Ram 3500, Aisen Trans, Short bed Crew Cab. B&W OEM Slider,
2018 Montana 3810MS
Russ & Nancy Porterfield
|