|
05-16-2022, 06:32 AM
|
#1
|
Established Member
Join Date: Apr 2021
Location: Joliet
Posts: 18
M.O.C. #28616
|
Slide out sequence
Good morning to one and all. I purchased my 3402 last year and the previous owner helped me set it up at my permanent site. This year I had extreme difficulty letting my slides out. I was attempting to let out the kitchen/living room slides first and it did not even try and move. After a half of a day tinkering we finally let out the bedroom slide first and then the kitchen/living room slides came out without incident.
I could not find anything in a manual that specifies a sequence in the slide outs. Is this typical of the 3402's?
Hoyett
|
|
|
05-16-2022, 07:21 AM
|
#2
|
Montana Master
Join Date: Feb 2012
Location: Lake Gaston
Posts: 8,773
M.O.C. #12156
|
Sequence has been different in all of our units. Commonality has been all downstair slides have been hydraulic and operated by a single switch. I would think individual slide weight would be the governing factor.
__________________
Mike and Lorraine
2002 3655 FL, 2005 3650RK
2010 3665RE, 2015 3910FB
F350 crew cab dually 6.7
|
|
|
05-16-2022, 07:22 AM
|
#3
|
Montana Master
Join Date: Dec 2017
Location: Mountain Home
Posts: 844
M.O.C. #20949
|
If these are all hydraulic then the motion sequence is..
1. Smallest slide will always open or close first ( usually the BR )
2. The two large slides will begin to move with the slide closest to the hydraulic
pimp fully closing first followed by the last slide that is farthest from the hydraulic pump
There is also an IRC ( individual room control ) that has a valve for each hydraulic slide that can be closed so that the slide will not move..
Also if this Montana never had the OEM 50 amp resettable breaker that runs from the battery area up to the dual polarity solenoid replaced this can open up and cause the slides to stop motion till breaker resets itself then move some more then trip again..
An 80 amp resettable breaker solves this issue
|
|
|
05-16-2022, 08:10 AM
|
#4
|
Established Member
Join Date: Apr 2021
Location: Joliet
Posts: 18
M.O.C. #28616
|
The kitchen & living room slides are on a single switch. The bedroom is on its own switch. The kitchen & living room would not move at all until I opened the bedroom slide. I thought this was extremely odd. Especially when I could not find anything on it at all...
|
|
|
05-16-2022, 08:12 AM
|
#5
|
Montana Master
Join Date: Oct 2006
Location: McKinney
Posts: 7,186
M.O.C. #6433
|
Seems they go out with the slide with least resistance first followed by next in that sequence.
You didn't specify the year, but the 3402 is probably old enough to still have a manifold just off the hydraulic pump with a black knob on it for each slide. You would have to experiment to find out which knob is which slide, but by closing one or more knobs you can isolate slides to operate only the one or ones you want. Not the easiest arrangement, but doable if the need should arise.
And I agree with the 50 amp circuit breaker. You may never have a problem with it, but good to do a search on here for slides starting and stopping and do a little reading on it just in case.
__________________
Bill & Patricia
Riley, our Golden
2007 3075RL (recently sold, currently without)
|
|
|
05-16-2022, 08:46 AM
|
#6
|
Established Member
Join Date: Apr 2021
Location: Joliet
Posts: 18
M.O.C. #28616
|
Thanks all. My 3402RL is a 2015 model.
|
|
|
05-16-2022, 09:34 AM
|
#7
|
Montana Master
Join Date: Oct 2012
Location: Box Elder
Posts: 4,712
M.O.C. #12947
|
Our 3402 has all hydraulic slides operated by the single switch and the bed goes first, followed by the kitchen then the TV slide and finally the large curb side slide. Operating the knobs behind the hatch where your leveling controls are will allow you to operate a single slide or restrict any or several slides.
__________________
Bob & Becky
2012 3402RL
2012 Chevy 2500HD D/A CC 4WD
|
|
|
05-16-2022, 05:31 PM
|
#8
|
Site Team
Join Date: Oct 2005
Location: Carmichael - CA
Posts: 7,394
M.O.C. #4831
|
On a 2015 wasn't the kitchen and dining slide hydraulic (as normal), but the bedroom was cable operated (i.e. electric)???
Why would operating the bedroom slide affect the hydraulic pump motor. Either an intermittent 50 amp breaker issue or a bad ground??
__________________
Carl (n Susan)
There is more to life than fuel mileage.
2012 Montana 3700RL Big Sky Package towed by a 2015 Ford F350 6.7L PSD 4WD CC LWB
|
|
|
05-17-2022, 07:35 AM
|
#9
|
Montana Master
Join Date: Feb 2012
Location: Lake Gaston
Posts: 8,773
M.O.C. #12156
|
Quote:
Originally Posted by Carl n Susan
On a 2015 wasn't the kitchen and dining slide hydraulic (as normal), but the bedroom was cable operated (i.e. electric)???
Why would operating the bedroom slide affect the hydraulic pump motor. Either an intermittent 50 amp breaker issue or a bad ground??
|
Good point. Our 2015 setup is just as described above. And separate switch for the bedroom.
__________________
Mike and Lorraine
2002 3655 FL, 2005 3650RK
2010 3665RE, 2015 3910FB
F350 crew cab dually 6.7
|
|
|
05-17-2022, 04:49 PM
|
#10
|
Montana Fan
Join Date: Feb 2022
Location: Cynthiana
Posts: 204
M.O.C. #30449
|
My 2017 has 2 switches on the interior panel; 1 is for bedroom only, the other switch controls the other 4. The little hydraulic pump doesn't have enough flow rate to run all 4 at the same time and they operate first come, first served. Mine has the water and cable connections as well as the dump valves in the "basement" bay under the bed slide. The hatch door doesn't open up even to horizontal to keep from hitting the bed slide. This is my most disliked feature; I've bumped my head numerous times and spewed many curse words because of that.
On my Level-up control, there is an individual switch for each of the 5 slides, I've never used it but that might be an option for you if it's so equipped.
|
|
|
05-22-2022, 02:35 PM
|
#11
|
Montana Fan
Join Date: Mar 2009
Location: Sun Lakes, AZ 85248
Posts: 179
M.O.C. #9174
|
About the 80Amp breaker
Do you know if a 2020 Montana would have the 80 amp breaker. I have a 3231CK.
__________________
Carl & Susan G
2021 Montana 3121RL Legacy
2017 Ford F250 6.7 diesel
|
|
|
05-22-2022, 05:01 PM
|
#12
|
Montana Master
Join Date: Aug 2004
Location: Livermore
Posts: 5,155
M.O.C. #1920
|
2020 had the 50 amp. 2021 was the changeover year.
__________________
Ron and Terrie Ames - MOC #1920/KF0NTA
2021Montana 3230CK Super Solar Legacy Package
2021 Ram 3500 Laramie Longhorn, BIM Charging
4x4, SRW, LB, Crew Cab, Pullrite 3900 Hitch
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|