Quote:
Originally Posted by Darval
ChuckS
Tha k you it is very helpful. Changes my entire thought of what I'm going to do. I am going to look into uhmw instead of galvanized metal. Thank you.
|
I would seek the opinions from some of the OPs on here that are much more experienced than I... but to me tape over the Darco is a total waste and a stop gap repair at best. if it evens holds...
UHMW can be bought in various sizes and thicknesses... I opted for the the .0125 thick stuff because I wanted the least amount of vertical height deflection when slide out ramps up on the wear bars...
I also wanted black to try and blend the repair in better with the Darco fabric.. I ordered a piece that was 12"x36"x .0125 and ripped it into four equal strips (minus saw blade kerf cut)... This stuff cuts like butter and does not melt like plastic would...
The bevel angle I cut on the leading edge was done with a miter saw and it cut as smooth as glass...
I drilled the initial attach screw holes and counter sunk on the work bench and then temp installed to see if the concept would work
After successful test I then removed strip and drilled additional holes and counter sunk them on the bench... Really would be a bear to do the additional countersinking with strip attached and working upside down...
anyways ... you have some thoughts to work out and perhaps others with ten times my ability and experience will chime in and you can get a really good repair action plan....
Please post whatever your final results and decisions turned out to be .. it will help others down the road when they have the same issues with the Darco