Quote:
Originally Posted by RMcNeal
Thanks again Chuck. I need to spend a little time tracing the wires from the switch, but what you have is basically what I was expecting. I wasn't sure if the switch went directly to Hydac valve or if it was passed through from the solenoid.
|
Yes each Hydac valve MUST HAVE its own separate source of 12 volt signal sent to it.. If the signal source was sent from the dual polarity solenoid extend or retract terminals the ALL hydac valves would open at the same time.. If you have six point hydraulic level up there are 3 hydac valves plus the separate hydac valve fro the hyd slide outs...
The signal wire form that slide switch will be easy to trace.. just look at the hydac valve for the slide outs and that color wire runs directly to the slide switch.